Conductive carbon fillers (carbon black, carbon fiber, and synthetic graphite particles) were added to Vectra A950RX liquid crystal polymer and the axial and radial thermal conductivities were determined experimentally for each composite. The addition of Thermocarb TC-300 synthetic graphite caused the largest increase in thermal conductivity, with in-plane thermal conductivity values reaching greater than 20 W/m K which is the minimum value for use in fuel cells. Mathematical models ...
As electronics get smaller and more powerful, the packaging that contains them must in turn become lighter with higher thermal conductivity and electrical resistivity. This study tested the effect of adding highly concentrated hexagonal boron nitride (hBN) fibers to liquid crystal polymer. The fibers were oriented in a way to achieve a high filler concentration, and the composites were then randomly added to a polyactide matrix. The researchers found that ...
Carbon nanotubes (CNTs) have extremely high thermal conductivity and can raise the thermal conductivity of a polymer matrix when used as an additive. Previous research has shown that random CNT orientation in polymer matrices gives a much lower thermal conductivity value than a specific alignment direction. This project tested the thermal conductivity of oils and polymers. Results were encouraging, with the thermal conductivity of the composites increasing linearly with the ...
This study is investigating how the thermal conductivity of a PMMA polymer filled with multi walled carbon nano tubes (MWNT) changes with temperature, and wt % MWNT. Also, the series, parallel, Lewis/Neilson and empirical formula models were used to quantify how well the measured values correlate with the calculated values. The thermal conductivity was measured with a transient plane source (TPS) method. The thermal conductivity of the polymer increased with ...
The goal of this study was to determine how adding CdS nanoparticles to two polymer blends (PS/PVC and PS/PMMA) affects their thermal conductivities. Also, the effect of increasing the wt% of both PVC and PMMA in their respective blends was investigated. The thermal conductivity of the samples was determined through a transient plane method. The thermal conductivity of both polymer blends increased with the addition of CdS nanoparticles. ...
