Thermal Conductivity Paper Database

Search academic papers below:

Recommended Papers for: Rebecca A. Hauser

Total Papers Found: 6

Effects of carbon fillers on the thermal conductivity of highly filled liquid-crystal polymer based resins

Carbon/liquid-crystal polymer composites were formulated. Composites containing one of three types of carbon filler, composites containing two types of carbon filler, and composites containing all three types of carbon filler were prepared to test not only the effect of each filler on the thermal conductivity of the composite, but also the effect of combining fillers. The anisotropic method on a TPS system was used for the thermal conductivity measurements. ...

Author(s): , , ,

Synergistic Effects and Modeling of Thermally Conductive Resins for Fuel Cell Bipolar Plate Applications

Conductive carbon fillers (carbon black, carbon fiber, and synthetic graphite particles) were added to Vectra A950RX liquid crystal polymer and the axial and radial thermal conductivities were determined experimentally for each composite. The addition of Thermocarb TC-300 synthetic graphite caused the largest increase in thermal conductivity, with in-plane thermal conductivity values reaching greater than 20 W/m K which is the minimum value for use in fuel cells. Mathematical models ...

Author(s):

Thermal conductivity models for single and multiple filler carbon/liquid crystal polymer composites 

Adding conductive fillers to polymer resins improves the thermal conductivity of the polymers. In this study, Thermocarb TC-300 synthetic graphite and Fortafil 243 carbon fiber were added to Vectra A950RX liquid crystal polymer (LCP) to produce anisotropic single and multiple filler composites. A Thermal Constants Analyzer measured the thermal conductivity of the composites using the transient plane source (TPS) technique. The formulations that contained Thermocarb fillers had higher in- and ...

Author(s): , , ,

Comparison of the guarded-heat-flow and transient-plane-source methods for carbon-filled nylon 6,6 composites: Experiments and modeling

Through the addition of synthetic graphite particles and carbon fiber to nylon 6,6 in amounts of 10-40 wt.% and 5-40 wt.% respectively, nylon composites were prepared. These composites were then analyzed using the guarded heat flow apparatus to measure through-plane thermal conductivity. Then the transient plane source (TPS) technique was used to measure the through-plane and in-plane thermal conductivities of the composites to compare to the guarded heat flow apparatus. A ...

Author(s): , , , ,

Synergistic Effects of Carbon Fillers in Thermally Conductive Liquid Crystal Polymer Based Resins

Three different carbons (carbon black, synthetic graphite particles and carbon fiber) were added to Vectra A950RX Liquid Crystal Polymer in order to synthesize different composites for use in fuel cells. The carbon fillers were used individually and also in combination with other carbon fillers. A TPS was used to measure the thermal conductivities of the synthesized composites. It was found that the use of synthetic graphite particles as the ...

Author(s): , , , ,