Al2O3 nanofluids were prepared with 2, 3, and 4 vol% Al2O3 nanoparticles in water for use as a coolant in plate heat exchangers. Using the transient plane source (TPS) technique, the thermophysical properties of the nanofluids were studied. Correlation equations were obtained for Nusselt number and the friction factor for the nanofluids and water. Less nanofluid is required to produce the same amount of cooling than water....
The authors used a variety of techniques to determine the thermal properties of polymethyl methacrylate (PMMA), including thermal conductivity, thermal diffusivity, specific heat and density. The measurements are performed in the temperature range from -70°C to 80°C. The results from the different techniques used to characterize the PMMA (GHP, GHF, TPS, THS) are all compared to see whether they agree with one another....
Very porous ceramics were prepared by the direct foaming method containing 79% kaolinite , based on commercial clay. Ceramics were prepared with different pore volume fractions, and the different ceramics were analyzed using the transient plane source (TPS) technique to measure thermal conductivity. Increasing pore volume fraction led to decreased thermal conductivity....
Through the addition of expanded graphite (EG) to polyethylene glycol, the authors were able to enhance the thermal conductivity of the phase change material (PCM). The transient plane source (TPS) technique was used to measure the thermal conductivity of the PCM. The amount of EG affected thermal conductivity, while amount of polyethylene glycol affected latent heat. Through the use of EG, the thermal conductivity was raised fourfold.....
The authors prepared PMMA/clay composites by the in situ bulk polymerization method. The prepared composites were characterized by FT-IR, WAXRD, SEM, TEM, DMA and the transient plane source (TPS) technique to measure thermal conductivity. Not only were the thermal properties of the composites studied, but physical and chemical properties as well....
