The Transient Plane Source Method is a helpful tool to test for the thermal conductivity of homogenous materials, however researchers at both the Chalmers University of Technology and Gothenberg University have created a process to test the thermal conductivities of inhomogeneous materials. For this experiment, a thermal analyzer was used to determine the thermal conductivities of four different sample materials (polymers and Pyrex glass) – each with different sizes and defects. ...
In this study, the thermal conductivity of alkanes was altered, by using inverse micellar templating and nanofibers. The main goal of this study was to create alkanes with tunable thermal conductivities, for their use as phase change materials in heat management. The thermal conductivity of an n-hexadecane product with inverse micelles of different volume fractions was analyzed. The tunable thermal conductivity of the micelle templated alkaline was determined to be ...
During a melt blending process, carbon nanotubes (CNTs) were added to a poly(vinylidene fluoride)/Boron nitride (PVDF/BN) composite, to increase the thermal conductivity of this polymer composite, for uses in the electronic industry. After this process, the thermal and electrical conductivities, along with any microstructure changes were investigated. It was determined that with the addition of CNTs, the thermal conductivity rating of the composite increased, as well as ...
Thermal conductivity testing was done on nitrogenated ultrananocrystalline diamond films on silicon. Temperature dependence on thermal conductivity was measured using these two techniques. A decrease in thermal conductivity was observed with the introduction of nitrogen addition. It was observed that MCD had the highest thermal conductivity followed by UNCD at 25% nitrogen and UNCD at 0% nitrogen....
