Lightweight LED heat sinks were fabricated by high-vacuum die casting (HVDC) using the aluminum alloy ADC12. Thermal characteristics of the heat sink were determined under natural convection using thermocouples and an IR thermograph, and the thermal conductivity was measured using the transient plane source (TPS) technique. It was determined that the castings were non-homogeneous and anisotropic....
The thermal conductivities of paraffin-based composite phase change materials (PCMs) containing different types of graphene nanoparticles were determined using the transient plane source method. It was determined that the thermal conductivity was increased by the addition of the nanoparticles, and the enhancement was greater for composites containing larger, and stiffer nanoparticles....
Polyactic acid (PLA)-micro hexagonal boron nitride (hBN)-graphene nanoplatelet (GNP) polymer composites were prepared, and the effects of varying filler contents on the thermal and mechanical properties of the polymer composites were investigated. It was determined that the addition of the GNPs resulted in a decrease in thermal conductivity in comparison to a PLA-hBN composite unless the GNP:hBN ratio was 1:1, where the thermal conductivity was equal to that ...
The thermal properties, as well as bulk density, and mass loss of alumina porcelain were determined as a function of firing temperature. It was found that after sintering at 1320 ºC, the thermal conductivity and thermal diffusivity increased by ~700% and ~400%, respectively....
Epoxy nanocomposites containing thermally reduced graphene oxides (TRGs) with different oxygen contents were prepared and their mechanical and thermal properties were investigated. It was found that increasing the number of oxygen containing groups on the TRGs resulted in reduced agglomeration of the graphene oxides within the epoxy matrix. Therefore, in samples with a higher oxygen content, a higher interfacial contact area is present between the organic and inorganic phases in ...
