Thermal Conductivity Paper Database

Search academic papers below:

Recommended Papers for: Transient plane source (TPS) method

Total Papers Found: 210

Intercomparison of thermal conductivity and thermal diffusivity methods for plastics

Thermal conductivity and thermal diffusivity of two poly(methyl methacrylates) were measured using multiple methods; temperature wave analysis, laser flash, transient plane source, transient line-source probe, and heat flux meter. The main reasoning behind this study was to compare results between methods, to ensure repeatability ...

Author(s): , , , , , ,

Measurements of thermal properties of insulation materials by using transient plane source technique

This article delves into the depths of the transient plane source (TPS) method for measuring thermal conductivity. When dealing with insulative materials, thermal conductivity is one of the most important thermal properties, as it directly reflects the R-value – amount of heat-transfer resistance the insulation provides. ...

Author(s):

Infrared Imaging During Thermal Conductivity Measurements

The transient plane source sensors were used to measure thermal conductivity and other thermophysical properties of infrared transparent materials, while under infrared imaging. The infrared imaging provided evidence of temperature uniformity and symmetry, as well as temperature monitoring of the sensor and material being tested. ...

Author(s): ,

Measurements of Building Materials by Transient Method

This paper highlights the use of the transient plane source (TPS) technique to test the thermal properties of porous building materials, such as autoclaved aerated concrete and calcium silicate boards reinforced by cellulose fibers. Transient methods relay multiple thermophysical parameters, such as thermal diffusivity, specific ...

Author(s): , ,

Thermal and Electrical Conductivity of Single- and Multi-walled Carbon nanotube-epoxy Composites 

Thermal conductivity measurements of the same samples were carried out using the TPS method. Thermal testing on carbon nanotubes to study for promising fillers.  Thermal conductivity of single-walled carbon nanotubes should enable a further reduction in the filler content required for a given enhancement in ...

Author(s): , , ,