The thermal and physical properties of concrete were investigated at high temperature to determine how these properties might change in the event of a fire. The influence of the type and content of aggregate was also investigated. It was found that the degradation and mass loss of concretes depends on the type of aggregate used. It was also determined that the porosity of concretes increases as temperature increases, and that ...
The authors examine the melting and crystallization behavior of a polyethylene/boron nitride composite to understand an unexpected exothermic peak when the BN content was greater than 10 wt. %. Based on these observations, an optimal annealing temperature of the composite was investigated to enhance its thermal conductivity. The appearance of the peak was determined to depend on the different nucleated capability of the different BN aggregates in local area. An annealing ...
The thermal properties of five sandstones were measured. The sandstones were taken from the base of Khewra located in Pakistan. The thermal conductivity, thermal diffusivity, and specific heat capacity were determined using the transient plane source technique, and the porosity and density of the sandstone samples were also determined. A formula for the estimation of thermal conductivity was modified to better fit the experimental data, and it was determined that ...
This report is a comprehensive compilation of a variety of studies performed on rock in a borehole at a potential nuclear waste storage facility in Sweden. Density, water absorption, mineral composition and thermal properties were studied to determine the site's suitability as a safe storage area. Thermal properties are an important factor since the nuclear waste canisters will continue to give off heat in storage due to nuclear fission, and ...
Carbon nanotubes (CNTs) have extremely high thermal conductivity and can raise the thermal conductivity of a polymer matrix when used as an additive. Previous research has shown that random CNT orientation in polymer matrices gives a much lower thermal conductivity value than a specific alignment direction. This project tested the thermal conductivity of oils and polymers. Results were encouraging, with the thermal conductivity of the composites increasing linearly with the ...
