Thermal Conductivity Paper Database

Search academic papers below:

Recommended Papers for: TPS Technique

Total Papers Found: 90

Thermophysical properties of styrene butadiene rubber filled with pine tree particles measured by the transient plane source technique

Using the transient plane source (TPS) technique, the effect of addition of pine tree particles to styrene butadiene rubber is studied. Thermal conductivity, thermal diffusivity, specific heat capacity and density were all investigated. Varying amounts of the pine tree filler particles were added to the ...

Author(s): , ,

Tailoring the structure of cellular vitreous carbon foams

The authors set out to prepare cellular vitreous carbon (CVC) foams with varying thermal and physical properties. This was accomplished by using tannin-based resin modified by different isocyanates in varying amounts. Three different experimental procedures were used to prepare foams with different physical and thermal ...

Author(s): , , , , ,

Experimental measurement of thermophysical properties of oxide-water nano-fluids down to ice-point

Two series of nanofluids were prepared by the researchers, using water as the carrier fluid, and Al2O3 and TiO2 as the nanoparticles; up to 6% particle volume fraction was used. The thermal conductivity and thermal diffusivity of the nanofluids were measured using the transient plane ...

Author(s): ,

Experimental analysis of heat transfer and friction factor of nanofluid as a coolant in a corrugated plate heat exchanger

Al2O3 nanofluids were prepared with 2, 3, and 4 vol% Al2O3 nanoparticles in water for use as a coolant in plate heat exchangers. Using the transient plane source (TPS) technique, the thermophysical properties of the nanofluids were studied. Correlation equations were obtained for Nusselt number and ...

Author(s): ,

Effect of the pore volume fraction on the thermal conductivity and mechanical properties of kaolin-based foams

Very porous ceramics were prepared by the direct foaming method containing 79% kaolinite , based on commercial clay. Ceramics were prepared with different pore volume fractions, and the different ceramics were analyzed using the transient plane source (TPS) technique to measure thermal conductivity. Increasing pore volume fraction ...

Author(s): , , , , , ,