Nano-inclusions are thermally conductive particles that improve the thermal conductivity of liquid mediums. In this paper, the thermal properties of Mg2Si were evaluated after the addition of TiO2 nanoparticles. An instrument measured the thermal conductivity of the nanofluid using the transient plane source (TPS) method. Results showed that the thermal conductivity of the nanofluid was the highest at lower temperatures, and did not improve with the addition of the ...
Phase change materials (PCMs) can be used as heat sinks to manage high temperature fluctuations in electronics. In this paper, a heat sink was generated from a paraffin/expanded graphite composite PCM, and the thermal conductivities of the materials were measured using the transient plane source (TPS) method of the Thermal Analyzer. Results showed that the composite PCM had a significantly higher thermal conductivity than the pure paraffin....
In this paper, natural rubber (NR)/graphene (GE) composites were prepared using an ultrasonically-assisted latex mixing and in situ reduction (ULMR) process. A thermal constants analyzer measured the thermal conductivity of the NR/GE composites using the transient plane source (TPS) method. Results showed that GE had a good thermal conductivity, and can be used as a thermal conductivity enhancer in polymers....
The first soy and tannin based organic aerogels with 91% naturality have been developed by researchers, and they have low bulk density but high volumes of mesopores. In this experiment, the transient plane source (TPS) method was used to measure the thermal characteristics of the organic aerogels. Results showed that these novelty aerogels are ecologically friendly because they are low cost and renewable but have attractive thermal properties....
The authors have developed a method for the functionalization of single-walled carbon nanotubes (SWCNTs). The functionalization of the SWCNTs is useful in helping to produce a better dispersion of nanotubes throughout a polymer matrix. Better dispersion of nanotubes was thought to result in an improvement in the mechanical, electrical, and thermal properties of nanocomposite polymers. It was determined that the method produced effective surface modification of the nanotubes. The elastic ...
