Polyactic acid (PLA)-micro hexagonal boron nitride (hBN)-graphene nanoplatelet (GNP) polymer composites were prepared, and the effects of varying filler contents on the thermal and mechanical properties of the polymer composites were investigated. It was determined that the addition of the GNPs resulted in a decrease in thermal conductivity in comparison to a PLA-hBN composite unless the GNP:hBN ratio was 1:1, where the thermal conductivity was equal to that ...
Poly(trimethylene terephthalate)-block-poly(tetramethylene oxide) (PTT-PMTO) copolymer-based nanocomposites containing a combination of single-walled carbon nanotubes (SWCNTs) and graphene nanoplatelets (GNPs) as carbon nanofillers were investigated to determine their thermal conductivities. Nanocomposites having a total carbon nanofiller concentration of 0.4 and 0.6 wt. % were preparared with varying amounts of each nanofiller, and the thermal conductivity was measured using the transient plane source (TPS) method. The dispersion of the nanofillers was observed by ...
Epoxy nanocomposites containing thermally reduced graphene oxides (TRGs) with different oxygen contents were prepared and their mechanical and thermal properties were investigated. It was found that increasing the number of oxygen containing groups on the TRGs resulted in reduced agglomeration of the graphene oxides within the epoxy matrix. Therefore, in samples with a higher oxygen content, a higher interfacial contact area is present between the organic and inorganic phases in ...
Zinc sulfide nanoparticles were embedded in a poly(methyl methacrylate) matrix to prepare a nanocomposite polymer with a higher thermal conductivity than the pure polymer. It was determined by TEM that at a low concentration of filler particles, the particles are uniformly dispersed throughout the matrix; however, at higher concentrations, agglomeration of the filler particles occurs. The effective thermal conductivity for all samples was found to increase with increasing temperature ...
CdS nanoparticles were dispersed in varying quantities into a PVC matrix and the effective thermal conductivities of the produced nanocomposites were investigated at temperatures from 25 to 110C. It was determined that the dispersion of the nanoparticles in PVC caused an increase in thermal conductivity up to 2 wt. % filler concentration when compared to that of pure PVC. When more than 2 wt. % of filler was added to the PVC matrix, the thermal ...
