Join us at the International Thermal Conductivity Conference (ITCC) and the International Thermal Expansion Symposium (ITES).

Thermal Conductivity Paper Database

Search academic papers below:

Recommended Papers for: Transmission electron microscopy (TEM)

Total Papers Found: 37

Effect of nanosized carbon black on the morphology, transport, and mechanical properties of rubbery epoxy and silicone composites

Rubber carbon black (CB)/rubbery epoxy (RE) and CB/silicone composites with different types, loadings, and silane functionalization of carbon black were prepared. These composites were investigated for their electrical conductivities, and their mechanical properties. The thermal conductivity of each composite was also determined using a thermal constants analyzer. It was determined that the incorporation of carbon black into the composites increased the thermal conductivity in all of the samples. ...

Author(s): , , , ,

Thermal properties and moisture absorption of nanofillers-filled epoxy composite thin film for electronic application

The effects of the addition of three different fillers to a polymer matrix on the thermo-physical properties of the resulting composites were investigated by the authors. Boron nitride, synthetic diamond, and silicon nitride were used as the fillers (up to 2 vol. %), and it was found that their addition did increase the thermal conductivity relative to that of the pure epoxy matrix. Furthermore, it was determined that the thermal conductivities of ...

Author(s): , ,

Thermal properties and rheological behavior of water based Al2O3 nanofluid as a heat transfer fluid

Polyactic acid (PLA)-micro hexagonal boron nitride (hBN)-graphene nanoplatelet (GNP) polymer composites were prepared, and the effects of varying filler contents on the thermal and mechanical properties of the polymer composites were investigated. It was determined that the addition of the GNPs resulted in a decrease in thermal conductivity in comparison to a PLA-hBN composite unless the GNP:hBN ratio was 1:1, where the thermal conductivity was equal to that ...

Author(s): , ,

Physical study of room-temperature-cured epoxy/thermally reduced graphene oxides with various contents of oxygen-containing groups

Epoxy nanocomposites containing thermally reduced graphene oxides (TRGs) with different oxygen contents were prepared and their mechanical and thermal properties were investigated. It was found that increasing the number of oxygen containing groups on the TRGs resulted in reduced agglomeration of the graphene oxides within the epoxy matrix. Therefore, in samples with a higher oxygen content, a higher interfacial contact area is present between the organic and inorganic phases in ...

Author(s): , , , , , , ,

Effects of inclusion size on thermal conductivity and rheological behavior of ethylene glycol-based suspensions containing silver nanowires with various specific surface areas

The effects of silver nanowire size on the thermal conductivities of ethylene glycol-based nanofluids were investigated experimentally. The effects of altering the loading concentration of nanowires, and altering the temperature were also investigated. In addition to this, an investigation into the effects of the nanowire dimensions on the rheological properties of the nanofluids was also conducted. Theoretical models were then developed based on the experimental results....

Author(s): , , , ,