This report is a comprehensive compilation of a variety of studies performed on rock in a borehole at a potential nuclear waste storage facility in Sweden. Density, water absorption, mineral composition and thermal properties were studied to determine the site's suitability as a safe storage area. Thermal properties are an important factor since the nuclear waste canisters will continue to give off heat in storage due to nuclear fission, and ...
Carbon nanotubes (CNTs) have extremely high thermal conductivity and can raise the thermal conductivity of a polymer matrix when used as an additive. Previous research has shown that random CNT orientation in polymer matrices gives a much lower thermal conductivity value than a specific alignment direction. This project tested the thermal conductivity of oils and polymers. Results were encouraging, with the thermal conductivity of the composites increasing linearly with the ...
Preventing steel from losing its strength during fires is crucial for safe evacuation and effective fire fighting. One of the most common protective coatings applied to steel and other construction materials today is intumescent paint. In this study, researchers created a potential new protective coating using a curable silicone base and varying volume amounts of expandable graphite between 5-25%. The key characteristic of these coatings is that they swell to ...
In this study, the insulating properties of building materials made out of recycled plant particles were tested with both the laser flash method and the Transient Plane Source (TPS) method. The tests were conducted with aggregates of sunflower pith with particle sizes 1, 1.5, and 2.5 mm, to see how the thermal conductivity behaves with increasing air volume fraction between grains. The TPS method produced values with an increasing trend for thermal conductivity ...
This study is investigating how the thermal conductivity of a PMMA polymer filled with multi walled carbon nano tubes (MWNT) changes with temperature, and wt % MWNT. Also, the series, parallel, Lewis/Neilson and empirical formula models were used to quantify how well the measured values correlate with the calculated values. The thermal conductivity was measured with a transient plane source (TPS) method. The thermal conductivity of the polymer increased with ...
