The thermal properties of synthetic gas hydrate-bearing sediment samples were determined by the transient plane source method. The samples were made up of sand, water, gas, and methane hydrates, and these samples were supercooled to minimize the effects of the heat of fusion of methane hydrate on the thermal conductivity measurements. The thermal conductivity was found to increase with increasing methane hydrate saturation for saturations from 0-0.3. Thermophysical models were ...
The author presents a literature review of current methods of determining thermal conductivity in order to select the best method for measuring TRISO fuel compacts. Based on the properties of the sample, the guarded-comparative-longitudinal heat flow technique was selected and a system was assembled to perform this measurement....
As electronics get smaller and more powerful, the components within them that handle heat dissipation must also evolve. Increasing power density and rising hot spots must be accouted for and handled. In this PhD dissertation, the author studies materials for potential use as heat spreaders or insulators at the nanoscale to understand their thermal properties. Nanostructured superlattices have shown to be highly effective in reducing the thermal conductivity of heat ...
Multi-walled carbon nanotube (MWCNT)/poly (methyl methacrylate) composites were prepared and their mechanical and physical properties were examined. An amphiphilic copolymer was used to aid in dispersing the MWCNTs throughout the composite. It was found that the use of this copolymer resulted in a good dispersal of the MWCNTs without drastically affecting the molecular weights of the composites, so it was concluded that the observed improvements in mechanical properties of ...
This government report discusses the possibility of using crystalline silicotitanate (CST) as a method of removing cesium from radioactive waste tanks at a storage facility. Thermal conductivity is an important factor in this process as cesium emits thermal energy, the solution used to remove it must be able to manage it or hot spots could develop through the column. The thermal conductivity of CST-air and CST-average stimulant mixtures was measured ...
