Sulfonated polystyrene-block-poly(ethylene-ran-butylene)-block-polystyrene (SPSPB) was used as a polymer matrix to create polymeric nanocomposites using graphite (G) and graphite-polyoxometalate (G-POM) as fillers. It was found that the nanocomposites had higher thermal and electrical conductivities than SPSPB alone, and that both the thermal and the electrical conductivity increased with increasing filler concentration. At all filler contents tested, the SPSPB/G-POM had both a higher thermal conductivity and a higher electrical ...
Three techniques were compared for the determination of thermal conductivity in poly-alpha-olefin (PAO)-based nanofluids. The three methods that were used were the transient hot wire, transient plane source, and laser flash techniques. The effects of temperature, nanoparticle concentration, and shape on the thermal conductivity were also examined, and these effects were compared to those predicted by a previously determined model. It was found that the transient hot wire technique ...
The authors have investigated the use of silver nanomaterials as a filler in epoxy resin in an effort to identify a composite resin with a high thermal conductivity for application as a thermal interface material. It was determined that the addition of silver nanoparticle and silver nanowires both increased the thermal conductivity of the resin, but the silver nanowires caused a much more drastic increase. It was found that by ...
This study investigates the effect changing the PH of a copper nanofluid and sodium dodecylbenzenesulfonate (SDBS) surfactant concentration has on the thermal conductivity of the nanofluid. The thermal conductivity was determined through the Hot Disk Transient Plane (TPS) method. As the PH is increased the thermal conductivity also increases because higher PH means more surface charges which increase conductivity. As the SDBS concentration is increased the thermal conductivity slightly increases ...
This study investigates the properties of a material to be used as an energy storage medium that can use energy stored from the summer months, and then release it during the winter. The proposed material uses a graphite foam, with ZnO coatings with a flower like morphology, to house a sugar alcohol phase change material (PCM). The thermal conductivity of the material was measured using a transient plane source (TPS) ...
