Polyether Ether Ketone (PEEK)/hexagonal boron nitride (h-BN) nanocomposites were formed by a planetary ball milling process and hot compression molding in order to determine the effect of the addition of h-BN on the properties of PEEK. In particular, the tensile strength, friction and wear behaviors, morphology, hardness, thermomechanical properties, and thermal conductivity of the nanocomposite were examined. Hexagonal boron nitride was added in filler concentrations of up to 5 wt. %. ...
Author(s): Lei Shang, Linghan Xiao, Liu Liu, Ming Li, Xiuping Zhang, Yanjie Chang, Yuhui Ao
The authors prepared PMMA/clay composites by the in situ bulk polymerization method. The prepared composites were characterized by FT-IR, WAXRD, SEM, TEM, DMA and the transient plane source (TPS) technique to measure thermal conductivity. Not only were the thermal properties of the composites studied, but physical and chemical properties as well....
Author(s): Chih-Bing Hung, Chih-Wei Peng, Hong-Ru Lin, Jui-Ming Yeh, Kung-Chin Chang, Mei-Chun Lai, Sheng-Chieh Hsu, Shyh-Shin Hwang
The authors highlight different methods of studying the purity, composition, and structural changes of polymeric and glass materials. These methods include the use of differential scanning calorimetry (DSC) and the transient plane source (TPS) technique. The quality of the TPS Technique is outlined and the authors praise the high quality of the machine. In addition to this, thermal analysis is carried out on some polymeric composites (cis-polyisoprene (CPI)/trans-polyisoprene (TPI) ...
Author(s): Arun Pratap, K. B. Sharma, Kananbala Sharma
Thermally Exfoliated Graphite Oxide (TEGO) was mixed with natural rubber (NR) using a two-roll mill but the mixing of the TEGO with the NR didn't proceed as expected. Therefore the researchers had to modify the procedure and decided to pre-mix the TEGO and NR in an ultrasonically-assisted latex co-coagulation process followed by two-roll milling resulted in significant improvement in the thermal and electrical properties of the nanocomposite compared to the ...
Author(s): Jeffrey R. Potts, Ling Du, Om Shankar, Rodney S. Ruoff, Shanthi Murali
A series of polymer-matrix composites were synthesized by using a variety of carbon nanotubes (single-walled carbon nanotubes (SWCNTs), double-walled carbon nanotubes (DWCNTs) and multi-walled carbon nanotubes (MWCNTs)) and a polymer matrix (either polystyrene (PS) or poly(methyl methacrylate) (PMMA)). Different surfactants and polymerization methods were also used in order to generate a wide range of different composites. These different composites were all tested for thermal and electrical conductivity and characterized ...
Author(s): A. Nykanen, J. Ruokolainen, J. Seppala, M. Annala, M. Lahelin
