This paper investigates the effect sulphate exposure has on the thermal conductivity and mechanical strength of low density cement based foams, with and without microfiber reinforcement. This was done by exposing these cement foams to sulfphate over 90 days. The compressive strength and flexural toughness displayed a cyclic rise and fall for the plain sample, and the opposite for the reinforced sample. The thermal conductivity showed an initial rise, but then ...
The thermal properties of oil palm shell (OPS) are investigated to determine if it could be used as a lightweight aggregate for a concrete mixture. The thermal conductivity, diffusivity, and specific heat were all tested through a transient plane source (TPS) method. The thermal conductivity and diffusivity both increased as the volume fraction of OPS increased. This is because OPS is very porous which gives it an inherently low thermal ...
This article investigates how the thermal conductivity of a resorcinol-formaldehyde aerogels varies with increasing resorcinol (R) to water (W) ratios. The thermal conductivity was measured using a transient plane source (TPS) method. As the R:W increases so does the thermal conductivity, this is because there is more conductive solids present to transfer more energy....
The production of closed cell foams has recently advanced as the materials gain interest. The purpose of this study was to use the transient plane source (TPS) method to measure the thermal conductivity of AlSi7 closed cell foams. Results showed that thermal conductivity increased with sample density, and experimental results were higher than the predictions of the theoretical models. Measurements were also carried out on different directions of the samples ...
The purpose of this study was to develop adhesive epoxy resins that used multiwalled carbon nanotubes (MWCNTs) to enhance thermal conductivity and dispersion in the polymer matrix. An analyzer measured the thermal conductivity of the MWCNTs-based epoxy adhesives using the transient plane source (TPS) method. Results showed that the addition of MWCNTs improved the coefficient of thermal conductivity of the epoxy resin in comparison to pristine epoxy and epoxy (EP)...
