The purpose of this study is to demonstrate the ability of a transient plane source (TPS) method to measure thermal conductivity, thermal diffusivity, and volumetric heat capacity. Four samples were tested standard steel, linear low-density polyethylene (LLDPE), LLDPE with 5 wt% graphite composite, and LLDPE with 15 wt% graphite composite. Steel had the highest thermal conductivity because steel has more free electrons then the other materials. LLDPE had a lower thermal conductivity ...
Thermal conductivity is one of the most important properties of fuel and cladding material. In this study, the thermal conductivity of uranium and T91 steel were measured using the transient plane source (TPS) method. Results showed that the thermal conductivity of T91 increased gradually to a point, then decreased. Fast reacting cladding materials require high thermal conductivities, and T91 was found to have higher conductivities than other commercial materials. As ...
The transient plane source (TPS) method is a popular technique that is used to measure the thermal properties of solids. The TPS method is widely used because it can test a variety of materials, it is easy to set up, and measurements are non-invasive. A downside of the TPS method is that it requires two homogenous samples, unlike invasive contact-probe techniques. This study proposes the idea of a “stamp sensor”, ...
The transient plane source (TPS) technique has a wide range of applications because of its capability to test solids, liquids, powders, and anisotropic materials over a range of sizes. Thermal properties of thin films and coatings can also be characterized using the TPS method if the samples are placed between the sensor and a bulk background. To minimize errors with the TPS method, use identical materials on each side of ...
Phosphosilicate ceramics with varying compositions were synthesized through the sol-gel process and the thermal conductivity of the samples was measured using the transient plane source (TPS) method. Results showed that the thermal conductivity of phosphosilicate ceramic powder was low, but increased slightly with phosphorous concentration. The low thermal conductivity of the ceramics could be useful in thermal barrier applications....
