Three different carbons (carbon black, synthetic graphite particles and carbon fiber) were added to Vectra A950RX Liquid Crystal Polymer in order to synthesize different composites for use in fuel cells. The carbon fillers were used individually and also in combination with other carbon fillers. A TPS was used to measure the thermal conductivities of the synthesized composites. It was found that the use of synthetic graphite particles as the ...
Using a three-roll mill process, graphite nanoplatelets (GNPs) were dispersed in a silicone polymer for application as a thermal interface material. Through the use of electron microscopy and XRD, the researchers were able to determine that the GNPs dispersed better when using the three-roll milling process as compared to previously used methods. GNPs were mixed with the silicone polymer in wt.% up to 25, with the highest wt.% yielding the highest ...
Thermally Exfoliated Graphite Oxide (TEGO) was mixed with natural rubber (NR) using a two-roll mill but the mixing of the TEGO with the NR didn't proceed as expected. Therefore the researchers had to modify the procedure and decided to pre-mix the TEGO and NR in an ultrasonically-assisted latex co-coagulation process followed by two-roll milling resulted in significant improvement in the thermal and electrical properties of the nanocomposite compared to the ...
Various polyacrylonitrile carbon fillers (Ketjenblack carbon black, Thermocarb synthetic graphite, Fortafil 243 carbon fiber, and Panex 30 carbon fiber) were added to a thermoplastic matrix in the hopes of generating a thermally conductive resin that could be used as bipolar plates in fuel cells. These composites were then tested for through-plane thermal conductivity using the Nielsen model which was a function of the single filler volume fraction. The authors also developed a ...
The low thermal conductivity of paraffin hinders its ability to be used as a PCM, and so in this article the authors created a composite made up of paraffin and micron-size graphite flakes (MSGFs) in order to hopefully increase thermal conductivity and energy storage capabilities. The results showed that increasing concentrations of MSGFs corresponded to 'enormous' increases in thermal conductivity. The addition of MSGFs to paraffin did not affect its ...
