The authors present a method of producing Cu2CdSnSe4 quaternary nanocrystals using a colloidal synthesis route that could be used for future industrial synthesis. The nanocrystals prepared showed great potential for use as a thermoelectric material due to their high thermoelectric figure of merit (up to 0.71) resulting from a high electrical conductivity and low thermal conductivity. The authors believed that these properties could be further tuned in order to increase ...
Three model polymer-bonded explosive compositions were prepared to determine the effects of damage on their mechanical and thermal properties. The composites were damaged in a controllable manner such that three different levels of damage could be produced, and the strain on the samples could be determined. The samples differed in the size of the particles that they contained, and the sample that showed the largest decrease in mechanical properties occurring ...
Composite carbon foams were prepared by mixing tannin-based resin with various graphite powders in an effort to improve the thermal conductivity relative to pristine carbon foams in order to use them as hosts for phase-change materials. It was found that using graphite powder with smaller particle sizes resulted in foams with a higher bulk density than those prepared with an equal amount of larger graphite particles, this increased density resulted ...
The authors have prepared highly porous, monolithic, carbon polymerised high internal phase emulsions (carboHIPEs) using tannins as the base material. This material was considered to be one of the most environmentally friendly carboHIPEs to have been prepared based on the fact that it is almost entirely composed of plant-derived chemicals. It was determined that in terms of porosity and mechanical properties, these carboHIPEs compared well with others that had been ...
The authors present a novel method for the preparation of highly porous tannin-based meringues by shear mechanical mixing of tannin, hexamine, and Kolliphore® ELP in water. The liquid foam was then cured in an oven at 85oC for 24 hours. The resultant solid foams were found to be homogeneous and they were also found to have similar thermal conductivity and other physical properties to tannin-based foams prepared by more traditional methods....
