Polytetramethylene ether glycol (PTMEG) was used to functionalize multi-walled carbon nanotube (MWNT) by grafting to produce MWNT-g-PTMEG. These functionalized nanotubes were then dispersed in thermoplastic polyurethane (TPU) to form a TPU/MWNT nanocomposite. It was found that the functionalization resulted in improved dispersion of the nanotubes in the TPU material. The tensile strength and elongation at break of the nanocomposite were also enhanced by the addition of the nanotubes in ...
The thermal and mechanical properties of PS/PMMA immiscible polymer blends were investigated. The effects of the dispersion of CdS nanoparticles on these properties were also investigated. The dispersion of the nanoparticles was found to result in an increase in glass transition temperature, as well as the thermal conductivity. The PS matrix was found to become more brittle and the PMMA matrix was found to become more compact upon the ...
Nanocomposites were prepared by the mixing of multi-walled carbon nanotubes (MWCNTs) with nitrile and hydrogenated nitrile elastomers (NBR and HNBR). A variety of methods including TEM, SEM, and XRD were used in order to investigate the morphology of the nanocomposites. Many mechanical properties of the nanocomposites were measured and reported. A machine was used to measure the thermal properties of the synthesized nanocomposites....
Thermally Exfoliated Graphite Oxide (TEGO) was mixed with natural rubber (NR) using a two-roll mill but the mixing of the TEGO with the NR didn't proceed as expected. Therefore the researchers had to modify the procedure and decided to pre-mix the TEGO and NR in an ultrasonically-assisted latex co-coagulation process followed by two-roll milling resulted in significant improvement in the thermal and electrical properties of the nanocomposite compared to the ...
