Discover the Next Chapter of Thermal Conductivity at ITCC-ITES 2024
Thermoelectric materials can be used to convert waste heat, such as solar energy and automobile exhaust, to electricity. A Bi0.45Sb1.55Te3 p-type cuboid was created using hydrothermal synthesis, cold pressing, and evacuated-and-encapsulated sintering in a Pyrex ampoule. The figure of merit (z) was determined by finding three transport parameters: electrical conductivity, thermopower, and thermal conductivity. The thermal conductivity measurements on the three (A, ...
Bi2-xSbxTe3 thermoelectric materials, where x = 1.52 and 1.55 were prepared and evaluated for their thermoelectric properties. Three samples in total were prepared, two with x = 1.52 and 1.55 were synthesized at 140oC and one with x = 1.55 was synthesized at 160 oC. It was determined that the two samples synthesized at the higher temperature had lower resistivity than that which was synthesized at higher temperature. The figure of merit for the sample synthesized at 140oC, ...
A series of Bi(2-x)Sb(x)Te3 powders were prepared via hydrothermal methods by varying x (x=1.45, 1.50, 1.55, 1.56). These powders were then heavily characterized by XRD, EDS, ICP-AES, TEM, SEM and the TPS technique. A low thermal conductivity was desired, so as to give the highest thermoelectric figure of merit (ZT). It was determined that the highest figure of merit was obtained when x=1.55, which resulted in a value of 1.65 ...