Join us at the International Thermal Conductivity Conference (ITCC) and the International Thermal Expansion Symposium (ITES).
Si-SiC composite foams were prepared using tannin-based foams as templates. The foams were prepared by four different methods for the determination of which method would best produce a foam with a pore size under 200 µm. The foam samples were characterized by SEM, XRD, and Raman spectroscopy, and the thermal conductivity of one of the foams was investigated by the transient plane source method. It was found that direct infiltration of ...
A variety of tannin-formaldehyde aerogels were produced in order to examine the effects of pH and dilution during their manufacture. The authors produced a phase diagram that could describe them. Extensive physical property characterization was performed on the sample aerogels, including porosity, thermal conductivity, volume shrinkage, BET surface area and microscopic texture. Conditions under which the highest surface area and pore volumes were produced were identified. The TPS instrument was ...
The purpose of this study was to produce an environmentally friendly foam using tannins, that did not contain any formaldehyde or blowing agents. Two experimental tannin foams were compared to two conventional foams, one containing both formaldehyde and blowing agents, and the other containing only a blowing agent. A variety of physical properties were assessed to determine if the new green formulation would be an appropriate replacement, this included thermal ...
Rigid foams were prepared using quebracho tannins and their physical and thermal properties were determined experimentally. These properties were then compared to those of rigid foams derived from mimosa tannins and pine tannins to determine if the nature of the flavonoid affects the properties of the foams. It was found that the preparation of the quebracho tannin-based foams involved the same formulation as that of mimosa tannin-based foams, whereas the ...
Composite carbon foams were prepared by mixing tannin-based resin with various graphite powders in an effort to improve the thermal conductivity relative to pristine carbon foams in order to use them as hosts for phase-change materials. It was found that using graphite powder with smaller particle sizes resulted in foams with a higher bulk density than those prepared with an equal amount of larger graphite particles, this increased density resulted ...
